Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 11 Next »


Within 2D views, only entities within the 2D View Cutting Planes tolerance are displayed. If objects which should be displayed are not shown, tolerance may be increased through Options > Dimensions/Tolerances > 2D View Cutting Planes +/-.

The blue up and down arrows change the elevation at which the 2D view is taken, as shown in Figure 1:


  • No labels

General-Topics | CSiBridge CSiCOL CSiPlant ETABS PERFORM-3D SAFE SAP2000 | Tutorials Test-Problems Documentation Licensing

Copyright © 2024 Computers and Structures, Inc. All rights reserved. | Powered by Atlassian