Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 21 Next »


CSI Software uses d’Alembert’s principal to automatically determine [acceleration loads] at each joint and element of a structure. These loads are used to simulate ground acceleration during time-history analysis. During time-history analysis, the acceleration record is automatically applied to all supports. The [CSI Analysis Reference Manual] (chapter: Load Cases, section: Acceleration Loads) explains this topic in greater detail.

To manually input ground motion at specific supports, it is necessary to convert the acceleration record to its corresponding displacement time-history record. This process, summarized in Appendix J of Dr. Edward L. Wilson’s text Static and Dynamic Analysis of Structures, is outlined below:

First, ground acceleration is idealized, within each time increment, as linear (Figure 1).


Unknown macro: {center-text}

Figure 1 - Ground acceleration record


At each time step, integration of acceleration and velocity then yields expressions for ground velocity and displacement (Figure 2).


Unable to render embedded object: File (Figure 5.png) not found.

Unknown macro: {center-text}

Figure 2 - Expressions for a, v, and d, derived through integration


Evaluation of these expressions at t = ∆t yields a set of recursive equations (Figure 3).


Unable to render embedded object: File (Figure 6.png) not found.

Unknown macro: {center-text}

Figure 3 - Recursive equations characterizing ground motion


These expressions may then be used to translate a ground acceleration record into its corresponding displacement record.

This double integration procedure should produce zero displacement at either end of the record. If non-zero displacement does exist, it is then necessary to apply a base line correction. Figure 4 presents a formulation for this process.


Unable to render embedded object: File (Figure 7.png) not found.

Unknown macro: {center-text}

Figure 4 - Algorithm for zero displacement at record ends


Once the displacement time-history record has been produced, users may continue to manually input ground motion at supports by following the process outlined in the [multi-support excitation] article.



Unknown macro: {hidden-content}

Previous page content:

The acceleration loads automatically calculated by the program are intended to apply ground acceleration. For example, translational acceleration loads are calculated as the negative translational joint mass at a joint times the input acceleration. CSI Analysis Reference Manual, chapter Load Patterns, section Acceleration Loads, has additional information on this.

To apply the acceleration load at the water level, you would need to convert the acceleration time history record to a displacement time history record. Once you have the displacement record, define a Load pattern in which you apply a unit value of joint displacements in the direction of acceleration at the affected joint. For this to affect the structure, you also need to restrain these joints in the direction of loading only. Then create a time history function that will describe a variation of these displacements in time. Finally, define a time history Load case that will be specified using both the displacement and the time function.

FAQ

Converting acceleration time history records to displacement time history records

Would it be appropriate for this user to use equations J.2 (provided in Appendix J of the book Static & Dynamic Analysis of Structures by Prof. Wilson) to convert acceleration time history records to displacement time history records?

Yes, that equation can be used to generate displacement history from the ground acceleration history. However, it should be borne in mind that the double integration of ground acceleration records should produce zero displacements at the end of the record. If this does not happen then it may be necessary to apply a base line correction to the displacement record.

Is the base line correction the same procedure as the "Algorithm to Set Displacements at End of Records to Zero" summarized in Table J.1 of Prof. Wilson's book?

Yes, that is one of the various methods available for base line correction.

  • No labels