Rigid behavior is often modeled using sufficiently large stiffness values. These values may be assigned using springs constants, property modifiers, section properties, or any other method which will produce the desired effect. This modeling procedure is typically adequate when rigid stiffness is not too large relative to the stiffness of connecting elements. Otherwise, linear problems may experience numerical sensitivity, and nonlinear problems may fail to converge. Restraints and constraints may be used to avoid these computational issues, but forces will not be generated, and additional problems may result from coupling behavior.

As described in greater detail in the Bearing and foundation springs article, we recommend that users simulate rigidity by using reasonably large stiffness values on the order of 1e11 kN-m (or kN-m/rad) for concrete systems.

See Also

• Bearing and foundation springs article