\\

CSI Software uses d’Alembert’s principal to automatically determine [acceleration loads|Acceleration load] at each joint and element of a structure. These loads are used in the application of ground acceleration during time-history analysis. The [CSI Analysis Reference Manual|doc:Analysis Reference Manual] (chapter: Load Cases, section: Acceleration Loads) explains this topic in greater detail.

To manually apply acceleration loads, it is necessary to first convert the acceleration time-history record into its corresponding displacement record. Appendix J of Dr. Edward L. Wilson’s text Static and Dynamic Analysis of Structures outlines this process.

To summarize Appendix J, within each time increment, ground acceleration is idealized as linear (Figure 1).

\\

!Figure 4.png|align=center,border=1!
{center-text}Figure 1 - Ground acceleration record{center-text}

\\

Integration of acceleration and velocity, at each time step, yields expressions for ground velocity and displacement (Figure 2).

\\

!Figure 5.png|align=center,border=1!
{center-text}Figure 2 - Expressions for a, v, and d, derived through integration{center-text}

\\

Evaluation of these expressions at t = ∆t yields a set of recursive equations (Figure 3).

\\

!Figure 6.png|align=center,border=1!
{center-text}Figure 3 - Recursive equations characterizing ground motion{center-text}

\\

These expressions may then be used to translate a ground acceleration record into its corresponding displacement record. 
The double integration procedure, previously described, should produce zero displacement at either end of the record. If non-zero displacement does exist, it is then necessary to apply a base line correction. Figure 4 presents a formulation for this process.

\\

!Figure 7.png|align=center,border=1!
{center-text}Figure 4 - Algorithm for zero displacement at record ends {center-text}

\\

Once the displacement time-history record has been produced, users may continue with manual acceleration-load application by defining a [load pattern|Load pattern] which applies, at joints of interest, joint-displacement unit values in the direction of simulated acceleration. It is also necessary to restrain these joints only in the direction of loading. Users may then create a time-history function which will envelope the response of these points, and finally, define a time-history [load case|Load case] which specifies both the displacement and the time function.