To simulate ground motion during time-history analysis,
CSI
Software automatically applies [acceleration loading] to all joints and elements of a structural model. These loads are determined through d’Alembert’s principal. As the [_CSI Analysis Reference Manual_] (Acceleration Loads, page 304) explains in greater detail, acceleration loads are derived from the application of the acceleration record to all supports.
To manually input ground motion at specific supports, it is necessary to convert the acceleration record to its corresponding displacement time-history record. This process, summarized in Appendix J of Dr. Edward L. Wilson’s text Static and Dynamic Analysis of Structures, is outlined below:
First, ground acceleration is idealized, within each time increment, as linear (Figure 1).
Figure 1 - Ground acceleration record
At each time step, integration of acceleration and velocity then yields expressions for ground velocity and displacement (Figure 2).
Unable to render embedded object: File (Figure 5.png) not found.
Figure 2 - Expressions for a, v, and d, derived through integration
Evaluation of these expressions at t = ∆t yields a set of recursive equations, as shown in Figure 3:
Unable to render embedded object: File (Figure 6.png) not found.
Figure 3 - Recursive equations characterizing ground motion
These expressions may then be used to translate a ground acceleration record into its corresponding displacement record.
This double integration procedure should produce zero displacement at either end of the record. If non-zero displacement does exist, it is then necessary to apply a base line correction. Figure 4 presents a formulation for this process.
Unable to render embedded object: File (Figure 7.png) not found.
Figure 4 - Algorithm for zero displacement at record ends
Once the displacement time-history record has been produced, users may continue to manually input ground motion at supports by following the process outlined in the [Multi-support excitation] article.
References
- Wilson, Dr. Edward L. Static & Dynamic analysis of Structures. 4th ed. Berkeley: Computers and Structures, Inc., 2004.
Available for purchase on theUnknown macro: {new-tab-link}Products >CSI
Unknown macro: {link-window}pageBooks