On this page:

Table of Contents

Model description

Create a new model from template. Define as a simple span, 40m long, with steel girders cross-section.
Release the bearing at the end abutment to achieve a simply supported condition.
Define point, line, and area loads in separate load cases as follows:
- Point load: 10kN load applied at station 20, centered transversely.
- Line load: 1kN/m load applied between stations 15 and 25, centered transversely.
- Area load: 0.1kN/m^2 load applied between stations 15 to 25 and across the width of the deck.
  
  These loads will all cause an effect equivalent to loading the bridge midspan with a 10kN point load
Run the analysis and check the midspan moments. For point loading, the theoretical midspan moment is given as follows:

...

Plan, elevation, and section diagrams depicting load application are given in Figure 1:

Image Modified

Figure 1 - Load application diagrams

...

Use the Loads > Loads - Point command to define a new point load, as shown in Figure 2:

Image Modified

Figure 2 - Define point load

...

Use the Bridge > Loads > Point Loads command to assign the previously defined point load, as shown in Figure 3:

Image Modified

Figure 3 - Assign point load

...

The moment diagrams below (Figures 4-6) depict the midspan moment expected.

Image Modified

Figure 4 - Point load moment diagram

Image Modified

Figure 5 - Line load moment diagram

Image Modified

Figure 6 - Area load moment diagram

Attachments

Name: Applying point, line, and area loads to bridge objects
Description: This tutorial demonstrates point-, line-, and area-load application to bridge objects.
Program: CSiBridge
Program Version: 15.0.0
Model ID: na

Show if