Page Comparison

h2. How is the depressed portion of a slab modeled such that elevation is differentvaries?

*Answer:* Slab elevation may be set by right-clicking on the slab which will be depressed, then within the Assignments tab, adjust the vertical offset relative to the top of the slab. Positive adjustment raises the slab, whereas negative depresses.

{info}
*NOTE:* Be sure to un-check Ignore Vertical Offsets, available through Run > Advanced Modeling Options, when manually adjusting slab elevation.
{info}

{hidden-content}
*Related Incident:*
* {incident:no=47395|comment=SAFE - depressed top of the slab}
{hidden-content}