On this page:
Table of Contents |
---|
The process for drawing section cuts within the graphical user interface is demonstrated using a cantilevered frame system (Figure 1) which has 1m segments extending along the positive global Z axis, then X, then Y. A point load of Fx = 1kN, Fy = 10kN, and Fz = 100kN is applied to the free end. After analysis is run, section cuts are drawn to obtain section-cut forces.
...
Figure 3 - Section-cut data
Show if | ||
---|---|---|
| ||
Section cut in 3D View For section cuts drawn in a 3D View, open questions are listed as follows:
|
Attachments
- SAP2000 V14.1.0 model (zipped .SDB file)
...